Danfoss iC7 Motion Series Application Manual page 143

Application Guide | iC7 Series Motion
Selection Number
0
1
2
P 4.3.3.11 Relative HF Injection Voltage Gain
Description: Set the voltage gain for HF injection relative to the recommended voltage.
Default Value: 100
Unit: %
P 4.3.3.12 Relative HF Inject Bandwidth
Description: Set the bandwidth for HF injection relative to the recommended bandwidth.
Default Value: 100
Unit: %
P 4.3.3.13 HF Injection Angle Comp. Gain
Description: Set the HF injection angle error compensation gain in degrees per nominal load torque.
Default Value: 0
Unit: °
P 4.3.3.14 HF Injection Angle Comp. Offset
Description: Set the HF injection angle error compensation offset in degrees.
Default Value: 0
Unit: °
P 4.3.3.15 HF Injection Frequency
Description: Set the HF injection frequency. Setting 0 is equal to automatic setting of injection frequency.
Default Value: 0
Unit: Hz
© 2023.11
Selection Name
Open loop
Closed loop with Feedback Device 1
Closed loop with Feedback Device 2
Parameter Type: Range (5 — 2000)
Data Type: REAL
Parameter Type: Range (1 — 1000)
Data Type: REAL
Parameter Type: Range (-35 — 35)
Data Type: REAL
Parameter Type: Range (-25 — 25)
Data Type: REAL
Parameter Type: Range (0 — \*)
Data Type: REAL
Selection Description
The motor is operated without feedback.
The motor control estimates the actual
speed.
The motor is operated with feedback,
providing speed and position feedback for
motor control from feedback device 1.
The motor is operated with feedback,
providing speed and position feedback for
motor control from feedback device 2.
Parameter Number: 2821
Access Type: Read/Write
Parameter Number: 2826
Access Type: Read/Write
Parameter Number: 2822
Access Type: Read/Write
Parameter Number: 2824
Access Type: Read/Write
Parameter Number: 2823
Access Type: Read/Write
AB318753549016en-000301 / 136R0284 |
141