Danfoss iC7 Motion Series Application Manual page 63

Application Guide | iC7 Series Motion
Press the down arrow on the control panel when in Readout Screen 1, and the control panel screen navigates to Readout Screen 2. As a
factory default setting, the control panel shows 3 readout values, as shown in the preceding image.
Adjusting Display Backlight and Contrast
3.2.6
When in Readout Screen 1 or Readout Screen 2, it is possible to adjust the backlight intensity and contrast of the display.
To adjust the display backlight and contrast settings, press the Info button and any of the arrow buttons of the control panel. The
settings are shown on the screen:
iC7_Industry
Motor Shaft Speed
Motor Torque
Motor Shaft Power
Figure 29: Intensity Change in Backlight and Contrast
To change the intensity of the backlight, keep pressing the Info button along with either the up and down arrow buttons of the
l
control panel.
To change the contrast, keep pressing the Info button along with either the left and right arrow buttons of the control panel.
l
Changing the Content of the Readout Screens
3.2.7
This chapter outlines an example procedure for changing or customizing the content of Readout Screen 1. The same procedure is
applicable for Readout Screen 2.
1.
To start the screen content editing mode, press OK for a minimum of 5 seconds. The screen changes as shown in the following
image.
iC7_Industry
Motor Frequency
Figure 30: Typical Readout Screen
2.
Remove an existing readout by pressing the up arrow button on the control panel and navigating to the Remove readout button
on the UI and pressing it.
Readout Screen 1
Motor Frequency
Figure 31: Add Readout and Remove Readout Buttons
When the remove readout button is pressed, the last readout on the list is removed.
© 2023.11
REM
0.0 Hz
0.0 rpm
0.00 Nm
0.00 kW
REM
0.0 Hz
0.0 Hz
Motor Frequency
OK
Readout Screen 1
+ +
Motor Frequency
Readout Screen 1
+
NOTICE
iC7_Industry
0.0 Hz
Motor Frequency
0.0 Hz
Line-To-Line Voltage (...399.5 v)
AB318753549016en-000301 / 136R0284 |
REM
61