Danfoss iC7 Motion Series Application Manual page 150

Application Guide | iC7 Series Motion
Default Value: 3 [Warning]
Unit: -
The following are the selections for the parameter.
Selection Number
0
1
3
Application (Menu Index 5)
6.6
Application Overview
6.6.1
This parameter group contains parameters for application specific features such as process control, speed control, torque control,
mechanical brake control, and many more.
Application Status (Menu Index 5.1)
6.6.2
P 5.1.1 Motor Ctrl. Status Word
Description: Shows the motor control status word.
Default Value: NA
Unit: -
P 5.1.2 Motor Ctrl. Ready Status Word
Description: Shows the motor control ready status word. All status bits must be true before the drive is ready.
Default Value: NA
Unit: -
P 5.1.3 Motor Regulator Status Word
Description: Shows the current state of the motor regulator status word. The status word indicates if a limit controller is active.
Default Value: NA
Unit: -
P 5.1.5 Fault Status Word 1
Description: Shows the fault status word 1.
148
| © 2023.11
Parameter Type: Selection
Data Type: UINT
Selection Name
Disable
Fault
Warning
Parameter Type: Range (\* — \*)
Data Type: WORD
Parameter Type: Range (\* — \*)
Data Type: WORD
Parameter Type: Range (\* — \*)
Data Type: WORD
Parameter Number: 2922
Access Type: Read/Write
Selection Description
Synchronization loss detection is disabled.
The drive issues a fault if this event
happens.
The drive will issue a warning if this event
happens.
Parameter Number: 1714
Access Type: Read Only
Parameter Number: 1716
Access Type: Read Only
Parameter Number: 1715
Access Type: Read Only
AB318753549016en-000301 / 136R0284