Danfoss iC7 Motion Series Application Manual page 276

Application Guide | iC7 Series Motion
Superimposed (Menu Index 5.19)
6.6.20
Superimposed Status (Menu Index 5.19.1)
6.6.20.1
P 5.19.1.1 Superimposed Status
Description: Shows the status of the superimposed movements.
Default Value: NA
Unit: -
The following are the selections for the parameter.
Selection Number
0
1
2
3
4
P 5.19.1.2 Superimposed Active Output
Description: Select a digital output to signal that a superimposed movement is on going.
Default Value:
Unit: -
P 5.19.1.3 Superimposed Target Reached Output
Description: Select a digital output to signal that the superimposed movement is completed.
Default Value:
Unit: -
P 5.19.1.4 Superimposed Error Output
Description: Select a digital output to signal that the superimposed movement is incomplete due to an error.
Default Value:
Unit: -
P 5.19.1.5 Superimposed Aborted Output
Description: Select a digital output to signal that the superimposed movement was aborted.
274
| © 2023.11
Parameter Type: Selection
Data Type: UINT
Selection Name
Idle
Active
Done
Error
Aborted
Parameter Type: Selection
Data Type: UINT
Parameter Type: Selection
Data Type: UINT
Parameter Type: Selection
Data Type: UINT
Parameter Number: 833
Access Type: Read Only
Selection Description
FeatureStatusDoneText.
FeatureStatusErrorText.
FeatureStatusAbortedText.
Parameter Number: 828
Access Type: Read/Write
Parameter Number: 829
Access Type: Read/Write
Parameter Number: 830
Access Type: Read/Write
AB318753549016en-000301 / 136R0284