Danfoss iC7 Motion Series Application Manual page 338

Application Guide | iC7 Series Motion
Default Value: 0 [Tri state]
Unit: -
The following are the selections for the parameter.
Selection Number
0
1
2
3
P 9.4.5.10 T16 Pulse Out Min. Frequency
Description: Set the frequency representing 0% of the signal.
Default Value: 0
Unit: Hz
P 9.4.5.11 T16 Pulse Out Max. Frequency
Description: Set the frequency representing 100% of the signal.
Default Value: 100000
Unit: Hz
Input T17 (Menu Index 9.4.6)
6.10.2.3.7
P 9.4.6.1 T17 Terminal Mode
Description: Select the mode for the terminal.
Default Value: 3 [Digital input]
Unit: -
The following are the selections for the parameter.
Selection Number
0
3
4
336
| © 2023.11
Parameter Type: Selection
Data Type: UINT
Selection Name
Tri state
Open collector sink (NPN)
Open collector source (PNP)
Push pull
Parameter Type: Range (0 — 100000)
Data Type: REAL
Parameter Type: Range (0 — 100000)
Data Type: REAL
Parameter Type: Selection
Data Type: UINT
Selection Name
Inactive
Digital input
Pulse input
Parameter Number: 2056
Access Type: Read/Write
Selection Description
Disable output (high impedance).
Open collector sink (NPN).
Open collector source (PNP).
Terminal can both sink and source.
Parameter Number: 2051
Access Type: Read/Write
Parameter Number: 2050
Access Type: Read/Write
Parameter Number: 2017
Access Type: Read/Write
Selection Description
The terminal is configured as boolean
input (true/false).
The terminal is configured as pulse input.
The frequency represents an analog value.
AB318753549016en-000301 / 136R0284