Danfoss iC7 Motion Series Application Manual page 232

Application Guide | iC7 Series Motion
P 5.9.2.6 Lower Window Limit
Description: Set the window size towards the positive speed direction.
Default Value: 0
Unit: Hz
P 5.9.2.7 Upper Window Limit
Description: Set the window size towards the negative speed direction.
Default Value: 0
Unit: Hz
P 5.9.2.26 Speed Limit Setpoint
Description: Set the variable speed limit setpoint in torque mode. This is used when fixed speed limits are not desired.
Default Value: 50
Unit: Hz
P 5.9.2.27 Speed Limit Setpoint Ramp Time
Description: Set the speed limit setpoint ramp time. When running in speed limit in torque mode, the drive will accelerate/decelerate
towards the speed limit setpoint using this ramp time.
Default Value: 5
Unit: s
P 5.9.2.28 Motoring Torque Limit Scale Input
Description: Select the input for scaling motoring torque limit between 0% and 100% value defined in motoring torque limit. Off equals
100%.
Default Value:
Unit: -
P 5.9.2.29 Regenerative Torque Limit Scale Input
Description: Select the input for scaling regenerative torque limit between 0% and 100% value defined in regenerative torque limit. Off
equals 100%.
Default Value:
Unit: -
P 5.9.2.30 Negative Torque Limit Scale Input
230
| © 2023.11
Parameter Type: Range (0 — 10)
Data Type: REAL
Parameter Type: Range (0 — 10)
Data Type: REAL
Parameter Type: Range (0 — 1000)
Data Type: REAL
Parameter Type: Range (0 — 10000)
Data Type: REAL
Parameter Type: Selection
Data Type: UINT
Parameter Type: Selection
Data Type: UINT
Parameter Number: 2333
Access Type: Read/Write
Parameter Number: 2334
Access Type: Read/Write
Parameter Number: 1336
Access Type: Read/Write
Parameter Number: 1337
Access Type: Read/Write
Parameter Number: 1324
Access Type: Read/Write
Parameter Number: 1326
Access Type: Read/Write
AB318753549016en-000301 / 136R0284