Danfoss iC7 Motion Series Application Manual page 133

Application Guide | iC7 Series Motion
Overview of Motor Nameplate Data
6.5.3.3
These parameters allow the setting of motor nameplate data.
Often, permanent magnet motors have torque but not power given on the motor nameplate. For those motors, set the speed and torque
product label settings, then the system calculates the power value. The system also calculates the torque value for asynchronous motors,
when the power and speed values are set.
When a higher priority parameter is set, the value of the lower priority parameter is calculated by the system. The parameters have the
following priority order:
1.
Nominal Power
2.
Nominal Speed
3.
Nominal Torque
To calculate the nominal torque of the motor, first set nominal power and then nominal speed.
To calculate nominal power of the motor, first set nominal speed and then nominal torque.
Motor Nameplate Data (Menu Index 4.2.2)
6.5.3.4
P 4.2.2.1 Nominal Power
Description: Set the nominal motor shaft power.
Default Value: 5.50
Unit: kW
P 4.2.2.2 Nominal Current
Description: Set the nominal motor current.
Default Value: 11.5
Unit: A
P 4.2.2.3 Nominal Speed
Description: Set the nominal motor shaft speed.
Default Value: 1450
Unit: rpm
P 4.2.2.4 Nominal Frequency
Description: Set the nominal motor frequency.
Default Value: 50
Unit: Hz
P 4.2.2.5 Nominal Voltage
© 2023.11
Parameter Type: Range (\* — \*)
Data Type: REAL
Parameter Type: Range (\* — \*)
Data Type: REAL
Parameter Type: Range (0 — 100000)
Data Type: REAL
Parameter Type: Range (0 — 2000)
Data Type: REAL
Parameter Number: 405
Access Type: Read/Conditional Write
Parameter Number: 400
Access Type: Read/Conditional Write
Parameter Number: 402
Access Type: Read/Conditional Write
Parameter Number: 403
Access Type: Read/Conditional Write
AB318753549016en-000301 / 136R0284 |
131