Danfoss iC7 Motion Series Application Manual page 125

Application Guide | iC7 Series Motion
Default Value: 0 [None]
Unit: -
The following are the selections for the parameter.
Selection Number
0
1
P 3.5.2 Filter Capacitance
Description: Set the capacitance of the output filter.
Default Value: \*
Unit: μF
P 3.5.3 Filter Inductance
Description: Set the inductance of the output filter.
Default Value: \*
Unit: mH
Additional Information for Output Filter
6.4.8
P 3.5.2 Filter Capacitance
Set the Cy (capacitance) value of the output filter. See the filter product label for the capacitance value. The value is the equivalent star-
connected capacitance of the filter. When the filters are installed in parallel, enter the combined capacitance value of the paralleled filter.
The value is the equivalent star-connected capacitance (Cy) of the filter multiplied by the number of installed paralleled filters.
P 3.5.3 Filter Inductance
Set the inductance of the output filter. See the product label of the filter for the value of inductance. When filters are installed in parallel,
enter the combined inductance value of the installed paralleled filters. The inductance value in the parameter is the inductance value of
the filter divided by the number of paralleled filters.
Motor (Menu Index 4)
6.5
Motor Overview
6.5.1
This parameter group contains parameters for configuring the motor, motor control, and motor protection.
Motor Status (Menu Index 4.1)
6.5.2
P 4.1.1 Motor Current
Description: Shows the actual motor current.
© 2023.11
Parameter Type: Selection
Data Type: UINT
Selection Name
None
Sine-wave Filter
Parameter Type: Range (0.00 —
1000000.00)
Data Type: REAL
Parameter Type: Range (0.00 — 1000.00)
Data Type: REAL
Parameter Number: 5501
Access Type: Read/Conditional Write
Selection Description
No output filter connected.
Sine-wave filter connected.
Parameter Number: 5502
Access Type: Read/Conditional Write
Parameter Number: 5503
Access Type: Read/Conditional Write
AB318753549016en-000301 / 136R0284 |
123