Danfoss iC7 Motion Series Application Manual page 291

Application Guide | iC7 Series Motion
P 5.1.3 Motor Regulator Status Word
Description: Shows the current state of the motor regulator status word. The status word indicates if a limit controller is active.
Default Value: NA
Unit: -
P 5.1.5 Fault Status Word 1
Description: Shows the fault status word 1.
Default Value: -
Unit:
P 5.1.8 Warning Status Word 1
Description: Shows the warning status word 1.
Default Value: -
Unit:
P 5.1.13 Application Status Word
Description: Shows the application-specific status word.
Default Value: NA
Unit: -
P 5.1.22 Motion Error Function Block Instance
Description:
Default Value: NA
Unit: -
P 5.1.23 Motion Error Information
Description: Shows the specific error information which was raised by a function block.
Default Value: NA
Unit: -
The following are the selections for the parameter.
© 2023.11
Parameter Type: Range (\* — \*)
Data Type: WORD
Parameter Type:
Data Type: DWORD
Parameter Type:
Data Type: DWORD
Parameter Type: Range (0 — 65535)
Data Type: WORD
Parameter Type: Range (0 —
4294967295)
Data Type: UDINT
Parameter Type: Selection
Data Type: UINT
Parameter Number: 1715
Access Type: Read Only
Parameter Number: 6203
Access Type: -
Parameter Number: 6205
Access Type: -
Parameter Number: 1608
Access Type: Read Only
Parameter Number: 1170
Access Type: Read Only
Parameter Number: 1171
Access Type: Read Only
AB318753549016en-000301 / 136R0284 |
289