Danfoss iC7 Motion Series Application Manual page 302

Application Guide | iC7 Series Motion
Selection Number
0
1
P 6.4.4.2 Auto Reset Max Attempts
Description: Set the maximum number of automatic resets that is allowed before a manual reset is required. 0 means the drive will auto
reset infinite times. Some events can not be auto reset due to hardware protection or for safety reasons.
Default Value: 3
Unit: -
P 6.4.4.3 Auto Reset Time Interval
Description: Set the time interval from when an event happens to when it is automatically reset.
Default Value: 10
Unit: s
Operational Counters (Menu Index 6.5)
6.7.5
P 6.5.1 Control Unit On Time
Description: Shows the total operating time for the control unit.
Default Value: 0
Unit: h
P 6.5.2 Power Unit On Time
Description: Shows the total operating time for the power unit. The counter only increments if the DC link is powered.
Default Value: 0
Unit: h
P 6.5.3 Energy Consumption
Description: Shows the energy consumed.
Default Value: 0
Unit: kWh
300
| © 2023.11
Selection Name
Disabled
Enabled
Parameter Type: Range (0 — 20)
Data Type: UINT
Parameter Type: Range (1 — 600)
Data Type: REAL
Parameter Type: Range (0 —
4294967295)
Data Type: UDINT
Parameter Type: Range (0 —
4294967295)
Data Type: UDINT
Parameter Type: Range (0 —
18446744073709600000)
Data Type: ULINT
Selection Description
Disables the function.
Enables the function.
Parameter Number: 1406
Access Type: Read/Write
Parameter Number: 1407
Access Type: Read/Write
Parameter Number: 2000
Access Type: Read Only
Parameter Number: 2001
Access Type: Read Only
Parameter Number: 2002
Access Type: Read Only
AB318753549016en-000301 / 136R0284