Danfoss iC7 Motion Series Application Manual page 260

Application Guide | iC7 Series Motion
Selection Number
0
1
Master (Menu Index 5.16)
6.6.17
Master Status (Menu Index 5.16.1)
6.6.17.1
P 5.16.1.1 Master Position
Description: Shows the actual position of the master in position units.
Default Value: NA
Unit: PositionUnit
Configuration (Menu Index 5.16.2)
6.6.17.2
P 5.16.2.1 Master Source Selection
Description: Select a source that provides the master signal.
Default Value: 0 [Disabled]
Unit: -
The following are the selections for the parameter.
Selection Number
0
2
3
P 5.16.2.2 Master Home Input
Description: Select a digital input for activating homing of the master. The actual master position is set to the value of the master home
position.
Default Value:
Unit: -
P 5.16.2.3 Master Home Position
Description: Set the master home position.
258
| © 2023.11
Selection Name
Touch Probe 1
Touch Probe 2
Parameter Type: Range (-2147483648 —
2147483647)
Data Type: DINT
Parameter Type: Selection
Data Type: USINT
Selection Name
Disabled
Feedback Device 1
Feedback Device 2
Parameter Type: Selection
Data Type: UINT
Selection Description
Parameter Number: 350
Access Type: Read Only
Parameter Number: 351
Access Type: Read/Write
Selection Description
Parameter Number: 354
Access Type: Read/Write
AB318753549016en-000301 / 136R0284