Danfoss iC7 Motion Series Application Manual page 356

Application Guide | iC7 Series Motion
Troubleshooting
7
Viewing Warnings
7.1
When a warning event occurs, the status indicators (halo and WARN) turn yellow. The drive remains operational and when the trigger for
the warning is corrected, the indicators turn white.
To view the details of a warning, go to parameter group 6.4.1 Active Events.
To view the history of events for the drive, go to parameter group 6.4.2 Event History.
iC7_Industry
1348.7 rpm 0.0 Nm
Active Events
X Reset all
!
SpeedTooHighWarning
Figure 94: Warnings
Viewing and Resetting Faults
7.2
When a fault occurs in the drive, the status indicators halo and FAULT turn red. The control panel display shows the name of the fault, and
allows a direct reset.
iC7_Industry
0.0 rpm 0.0 Nm
X Reset all
SpeedTooHighFault
Figure 95: Fault on the Control Panel
1.
To view details about a fault and its cause, select the fault in the list shown on the control panel and press [OK].
If the control panel display has changed, simultaneously press the left and right arrows on the control panel to return to
parameter group 6.4.1 Active Events.
iC7_Industry
0.0 rpm
SpeedTooHighFault
Figure 96: View Active Faults
2.
Resolve all triggers causing the fault.
3. Select Reset all and press [OK].
354
| © 2023.11
REM
0.0 kW
REM
0.0 kW
REM
0.0 Nm 0.0 kW
X Reset all
8480h-5290
Speed Too High
Speed Monitor: Fault for too high
speed
AB318753549016en-000301 / 136R0284