Danfoss iC7 Motion Series Application Manual page 290

Application Guide | iC7 Series Motion
Default Value:
Unit: -
P 4.1.23 Motor Power Output
Description: Select an output for the motor power signal. The scale of the signal is 0–100% of the nominal power.
Default Value:
Unit: -
P 4.1.24 AMA Progress
Description: Shows the progress of the Automatic Motor Adaptation (AMA).
Default Value: NA
Unit: %
P 4.1.26 Motor Temperature
Description: The analog temperature sensor has exceeded the configured value.
Default Value: NA
Unit: °C
P 4.1.28 Rs Measured
Description: When a Rs measurement has been stored for use after drive power recycle, the value is shown here; otherwise it is zero.
Default Value:
Unit: Ω
Application Status (Menu Index 5.1)
6.7.2.5
P 5.1.1 Motor Ctrl. Status Word
Description: Shows the motor control status word.
Default Value: NA
Unit: -
P 5.1.2 Motor Ctrl. Ready Status Word
Description: Shows the motor control ready status word. All status bits must be true before the drive is ready.
Default Value: NA
Unit: -
288
| © 2023.11
Parameter Type: Selection
Data Type: UINT
Parameter Type: Selection
Data Type: UINT
Parameter Type: Range (0 — 100)
Data Type: REAL
Parameter Type: Range (-300 — 300)
Data Type: REAL
Parameter Type: Range (0 — 1000000)
Data Type: REAL
Parameter Type: Range (\* — \*)
Data Type: WORD
Parameter Type: Range (\* — \*)
Data Type: WORD
Parameter Number: 2309
Access Type: Read/Write
Parameter Number: 2305
Access Type: Read/Write
Parameter Number: 429
Access Type: Read Only
Parameter Number: 1630
Access Type: Read Only
Parameter Number: 433
Access Type: Read/Write
Parameter Number: 1714
Access Type: Read Only
Parameter Number: 1716
Access Type: Read Only
AB318753549016en-000301 / 136R0284