Danfoss iC7 Motion Series Application Manual page 171

Application Guide | iC7 Series Motion
5.5.3.1 Settings
(Functionality settings for the control panel)
5.5.3.2 References
(Types of reference for speed control, torque control,
and process control when controlled by the panel)
5.5.4.1References
(Max. 2 reference types per Operation Mode
which can be combined by logic)
5.5.5.1 Commands
(Selection of digital inputs for the commands Start, Start Backwards,
Stop Inverse, Coast Inverse, Reversing, Reset (one per command))
5.5.5.2 References
(Maximum of 2 reference types per Organisation Mode.
Reference types can be combined by logic)
5.5.6.1 Commands
(Selection of input types for the commands Start, Start Backwards, Stop
Inverse, Coast inverse, Reversing, Reset (maximum of two per command,
input types can be combined by logic))
5.5.6.2 References
(Maximum of two reference types per Operation Mode.
Reference types can be combined by logic)
Figure 76: Control Places
Control Places Status (Menu Index 5.5.1)
6.6.7.2
P 5.5.1.1 Active Control Place
Description: Shows the control place that controls the drive.
Default Value: NA
Unit: -
The following are the selections for the parameter.
Selection Number
0
1
2
3
4
P 5.5.1.2 Local Control Active Output
Description: Select an output terminal indicating that the drive is in local control.
© 2023.11
Control Places
5.5.3 Local Control
5.5.4 Fieldbus Control
5.5.5 I/O Control
5.5.6 Advanced Control
Parameter Type: Selection
Data Type: UINT
Selection Name
PC control
Local control
Fieldbus control
I/O control
Advanced control
Control Place Selection
(Parameter 5.5.2.1)
Command sources
and references types
for the selected control
Parameter Number: 113
Access Type: Read Only
Selection Description
The drive is controlled by a software tool.
The drive is controlled by a connected
control panel.
The drive is controlled via a fieldbus.
The drive is controlled via I/O.
The drive is controlled via a combination
of I/O and fieldbus.
AB318753549016en-000301 / 136R0284 |
place
169