Danfoss iC7 Motion Series Application Manual page 310

Application Guide | iC7 Series Motion
Selection Number
897
9013
P 8.3.1.3 Readout Field 1.3
Description: Select the parameter for readout field (screen 1 field 3).
Default Value: 0 [None]
Unit: -
The following are the selections for the parameter.
Selection Number
0
9011
9000
9010
9009
1708
9005
9008
674
666
1718
6151
6153
6155
308
| © 2023.11
Selection Name
Distance Measurement Counter
Superimposed Actual Distance
Parameter Type: Selection
Data Type: UDINT
Selection Name
None
Motor Speed
Motor Current
Motor Shaft Speed
Motor Torque
Relative Motor Torque
Motor Voltage
Motor Shaft Power
Load Drooping Speed
Estimated Inertia
Speed Reference
Final Speed Reference
Control Panel Speed Reference
Local Torque Reference
Selection Description
Shows a continuous counter which is
incremented with each occurrence of a
distance calculation. The counter will start
from 0 and wraps around when exeeding
65535. The counter is reset to 0 when a
source selection is set to Disabled.
Shows the actual covered distance of
an active superimposed movement.
The value is reset a every start of a
superimposed movement.
Parameter Number: 302
Access Type: Read/Write
Selection Description
Nothing selected.
Shows the actual motor speed.
Shows the actual motor current.
Shows the shaft speed in RPM.
Shows the actual motor torque.
Shows the motor torque in % of the
nominal motor torque.
Shows the actual motor voltage.
Shows the actual power at the motor
shaft.
Shows the load drooping speed.
Shows the speed reference.
Shows the value of the speed reference
before feeding it to the speed controller.
Shows the value of the speed reference
given from the control panel.
Shows the local torque reference set in the
control panel.
AB318753549016en-000301 / 136R0284