Danfoss iC7 Motion Series Application Manual page 275

Application Guide | iC7 Series Motion
P 5.18.3.1.3 Distance Measurement Counter
Description: Shows a continuous counter which is incremented with each occurrence of a distance calculation. The counter will start
from 0 and wraps around when exeeding 65535. The counter is reset to 0 when a source selection is set to Disabled.
Default Value: NA
Unit: -
P 5.18.3.1.4 Distance Measurement Counter Output
Description: Select an analog output to represent the value of the result counter. The signal is scaled between 0 and 65535.
Default Value:
Unit: -
Configuration (Menu Index 5.18.3.2)
6.6.19.3.2
P 5.18.3.2.1 Selection Source A
Description: Select a digital input for source A for distance measurement.
Default Value: 0 [Off]
Unit: -
The following are the selections for the parameter.
Selection Number
0
1
2
P 5.18.3.2.2 Selection Source B
Description: Select a digital input for source B for distance measurement.
Default Value: 0 [Off]
Unit: -
The following are the selections for the parameter.
Selection Number
0
1
2
© 2023.11
Parameter Type: Range (0 — 65535)
Data Type: UINT
Parameter Type: Selection
Data Type: UINT
Parameter Type: Selection
Data Type: UINT
Selection Name
Off
Touch Probe 1
Touch Probe 2
Parameter Type: Selection
Data Type: UINT
Selection Name
Off
Touch Probe 1
Touch Probe 2
Parameter Number: 897
Access Type: Read Only
Parameter Number: 809
Access Type: Read/Write
Parameter Number: 898
Access Type: Read/Write
Selection Description
The feature is disabled.
Parameter Number: 899
Access Type: Read/Write
Selection Description
The feature is disabled.
AB318753549016en-000301 / 136R0284 |
273