Danfoss iC7 Motion Series Application Manual page 259

Application Guide | iC7 Series Motion
Default Value: 1
Unit: -
P 5.15.3.3 Gear Ratio Denominator
Description: Set the denominator for the gear ratio used in gear mode. Is used in combination with gear ratio numerator.
Default Value: 1
Unit: -
P 5.15.3.4 Superimposed Speed Difference
Description: Set the speed reference for the superimposed motion which will be added to the acutal speed of the underlying motion.
Default Value: 10
Unit: Hz
Marker Correction Settings (Menu Index 5.15.4)
6.6.16.4
P 5.15.4.1 Master Marker Selection
Description: Select which signal is used as master marker sensor.
Default Value: 0 [Touch Probe 1]
Unit: -
The following are the selections for the parameter.
Selection Number
0
1
P 5.15.4.2 Follower Marker Selection
Description: Select which signal is used as the follower marker sensor.
Default Value: 1 [Touch Probe 2]
Unit: -
The following are the selections for the parameter.
© 2023.11
Parameter Type: Range (-2147483648 —
2147483647)
Data Type: DINT
Parameter Type: Range (-2147483648 —
2147483647)
Data Type: DINT
Parameter Type: Range (0.000000001 —
16777216)
Data Type: REAL
Parameter Type: Selection
Data Type: UINT
Selection Name
Touch Probe 1
Touch Probe 2
Parameter Type: Selection
Data Type: UINT
Parameter Number: 328
Access Type: Read/Write
Parameter Number: 329
Access Type: Read/Write
Parameter Number: 823
Access Type: Read/Write
Parameter Number: 330
Access Type: Read/Write
Selection Description
Parameter Number: 331
Access Type: Read/Write
AB318753549016en-000301 / 136R0284 |
257