Danfoss iC7 Motion Series Application Manual page 294

Application Guide | iC7 Series Motion
Default Value: NA
Unit: -
The following are the selections for the parameter.
Selection Number
0
1
2
3
Control Places Status (Menu Index 5.5.1)
6.7.2.8
P 5.5.1.1 Active Control Place
Description: Shows the control place that controls the drive.
Default Value: NA
Unit: -
The following are the selections for the parameter.
Selection Number
0
1
2
3
4
P 5.5.1.2 Local Control Active Output
Description: Select an output terminal indicating that the drive is in local control.
Default Value:
Unit: -
P 5.5.1.3 Fieldbus Control Active Output
Description: Select an output terminal indicating that the drive is in fieldbus control.
292
| © 2023.11
Parameter Type: Selection
Data Type: UINT
Selection Name
Inactive
In progress
Completed successfully
Completed unsuccessfully
Parameter Type: Selection
Data Type: UINT
Selection Name
PC control
Local control
Fieldbus control
I/O control
Advanced control
Parameter Type: Selection
Data Type: UINT
Parameter Number: 666
Access Type: Read Only
Selection Description
Parameter Number: 113
Access Type: Read Only
Selection Description
The drive is controlled by a software tool.
The drive is controlled by a connected
control panel.
The drive is controlled via a fieldbus.
The drive is controlled via I/O.
The drive is controlled via a combination
of I/O and fieldbus.
Parameter Number: 5178
Access Type: Read/Write
AB318753549016en-000301 / 136R0284