Danfoss iC7 Motion Series Application Manual page 103

Application Guide | iC7 Series Motion
Selection Number
0
1
P 1.3.9 Grid Voltage Imbalance Response
Description: Select the mode of grid imbalance protection.
Default Value: 1 [Fault or Warning]
Unit: -
The following are the selections for the parameter.
Selection Number
0
1
2
P 1.3.10 Grid Spike Response
Description: Select the response to grid voltage spike monitoring. If large spikes occur, it will protect the drive.
Default Value: 3 [Warning]
Unit: -
The following are the selections for the parameter.
Selection Number
3
9
Power Conversion & DC Link (Menu Index 2)
6.3
Power Conversion & DC-Link Overview
6.3.1
This parameter group contains parameters for configuring, monitoring, and controlling the power conversion of the drive. The group lets
the user configure protection settings of the power unit and settings for the rectifier, DC link, and inverter.
Power Conversion & DC Link Status (Menu Index 2.1)
6.3.2
P 2.1.1 Unit Nominal Voltage
Description: Shows the nominal voltage setting as a result of the setting of parameter "2.2.1.1 Unit Voltage Class".
© 2023.11
Selection Name
Disabled
Enabled
Parameter Type: Selection
Data Type: UINT
Selection Name
Off
Fault or Warning
Automatically derate
Parameter Type: Selection
Data Type: UINT
Selection Name
Warning
Fault, ramp to coast
Selection Description
Disables the function.
Enables the function.
Parameter Number: 9056
Access Type: Read/Write
Selection Description
Disables the protection.
Issues a warning or fault if a grid voltage
imbalance is detected.
The drive continues operation with
derated performance.
Parameter Number: 2342
Access Type: Read/Write
Selection Description
The drive issues a warning.
Issues a fault, ramps down, and coast.
AB318753549016en-000301 / 136R0284 |
101