Danfoss iC7 Motion Series Application Manual page 191

Application Guide | iC7 Series Motion
Selection Number
0
1
2
3
4
5
6
7
P 5.5.6.2.12 Adv Position Reference
Description: Select the position reference sources for when the drive operates in advanced control. Define multiple entries for
combining several sources into 1 reference value.
Default Value: [2,5]
Unit: -
The following are the selections for the parameter.
Selection Number
0
2
3
4
5
P 5.5.6.2.13 Adv Position Reference Logic
Description: Select how to form the position reference out of the 2 inputs when operating in advanced control.
Default Value: 2 [Sum]
Unit: -
The following are the selections for the parameter.
© 2023.11
Selection Name
Source 1
Source 2
Sum
Subtract
Divide
Multiply
Maximum
Minimum
Parameter Type: Selection
Data Type: UINT
Selection Name
None
Fieldbus reference
Reference 1 input
Reference 2 input
Preset reference
Parameter Type: Selection
Data Type: UINT
Selection Description
Use value from source 1 only.
Use value from source 2 only.
Add references from source 1 and 2
together.
Subtract source 2 from source 1.
Divide source 1 with source 2.
Multiply source 1 with source 2.
Use highest value of source 1 and source
2.
Use lowest value of source 1 and source 2.
Parameter Number: 1976
Access Type: Read/Write
Selection Description
No source selected equals a 0 value.
Use reference from the fieldbus.
Use the reference from I/O reference 1.
Use the reference from I/O reference 2.
Use reference from the preset reference.
Parameter Number: 1949
Access Type: Read/Write
AB318753549016en-000301 / 136R0284 |
189