Danfoss iC7 Motion Series Application Manual page 257

Application Guide | iC7 Series Motion
The following are the selections for the parameter.
Selection Number
0
1
3
4
5
P 5.15.1.2 Synchronizing Active Output
Description: Select a digital output to signal that synchronizing is active.
Default Value:
Unit: -
P 5.15.1.3 Synchronizing In Sync Output
Description: Select a digital output to signal that the drive is in sync with the master. Tolerance for in sync is set by the synchronization
window.
Default Value:
Unit: -
P 5.15.1.4 Synchronizing Aborted Output
Description: Select a digital output to signal that synchronizing has been aborted, for example, by a stop command.
Default Value:
Unit: -
P 5.15.1.5 Synchronizing Error Output
Description: Select a digital output to signal that synchronizing has been aborted or not started due to an error.
Default Value:
Unit: -
Configuration (Menu Index 5.15.2)
6.6.16.2
P 5.15.2.1 Start Synchronizing Input
Description: Select a digital input for starting synchronization. Start behavior defines at which point the follower position is locked to the
master position. The signal is level triggered.
© 2023.11
Selection Name
Idle
Active
Error
Aborted
In Sync
Parameter Type: Selection
Data Type: UINT
Parameter Type: Selection
Data Type: UINT
Parameter Type: Selection
Data Type: UINT
Parameter Type: Selection
Data Type: UINT
Selection Description
FeatureStatusErrorText.
FeatureStatusAbortedText.
FeatureStatusInSyncText.
Parameter Number: 320
Access Type: Read/Write
Parameter Number: 321
Access Type: Read/Write
Parameter Number: 322
Access Type: Read/Write
Parameter Number: 323
Access Type: Read/Write
AB318753549016en-000301 / 136R0284 |
255