Danfoss iC7 Motion Series Application Manual page 80

Application Guide | iC7 Series Motion
Figure 55: Apply settings

After the signal selection and the datalogger settings, the datalogger is ready to record the logs. To view a recorded datalog file,
click the icon shown in the following figure.
Figure 56: Datalogger view icon
Backup and Restore
3.3.7
MyDrive® Insight Backup
3.3.7.1
The Backup feature in MyDrive® Insight allows storing the parameter settings of the drive into a new or existing project file, RAM, or Flash
memory of the drive, or to an optional microSD card.
To use the microSD card as a storage device, the microSD card must be inserted in the slot on the interface module located behind the
control panel, as shown in the following image.
Figure 57: MicroSD Card Slot
1
The microSD card slot
The following are the types of microSD card supported by the interface module. The card must be formatted for the file system FAT32.
Secure Digital (SD) card
l
Secure Digital High Capacity (SDHC)
l
Secure Digital Extended Capacity (SDXC)
l
Note:
It is recommended to use SDHC cards as they are delivered preformatted to FAT32.
78
| © 2023.11
1
1
AB318753549016en-000301 / 136R0284