Danfoss iC7 Motion Series Application Manual page 272

Application Guide | iC7 Series Motion
Default Value:
Unit: -
P 5.18.2.1.7 Touch Probe 2 Counter
Description: Shows the number of detected touch probe 2 events since the counter was reset.
Default Value: NA
Unit: -
P 5.18.2.1.8 Touch Probe 2 Counter Output
Description: Select an analog output to represent the number of detected touch probe 2 events. The signal is scaled between 0 and
65535.
Default Value:
Unit: -
Configuration (Menu Index 5.18.2.2)
6.6.19.2.2
P 5.18.2.2.1 Touch Probe 2 Input
Description: Select a digital input for connection of the touch probe 2 sensor.
Default Value:
Unit: -
P 5.18.2.2.2 Touch Probe 2 Enable Input
Description: Select a digital input for activating touch probe 2 monitoring.
Default Value:
Unit: -
P 5.18.2.2.3 Touch Probe 2 Edge
Description: Select the signal edge to trigger touch probe 2.
Default Value: 0 [Rising]
Unit: -
The following are the selections for the parameter.
270
| © 2023.11
Parameter Type: Selection
Data Type: UINT
Parameter Type: Range (0 — 65535)
Data Type: UINT
Parameter Type: Selection
Data Type: UINT
Parameter Type: Selection
Data Type: UINT
Parameter Type: Selection
Data Type: UINT
Parameter Type: Selection
Data Type: UINT
Parameter Number: 806
Access Type: Read/Write
Parameter Number: 895
Access Type: Read Only
Parameter Number: 807
Access Type: Read/Write
Parameter Number: 883
Access Type: Read/Write
Parameter Number: 884
Access Type: Read/Write
Parameter Number: 889
Access Type: Read/Write
AB318753549016en-000301 / 136R0284