Danfoss iC7 Motion Series Application Manual page 13

Application Guide | iC7 Series Motion
Introduction to the Application Guide
1
Version History
1.1
This guide is regularly reviewed and updated. All suggestions for improvement are welcome.
The original language of this guide is in English.
Version
M00106, document version 03
Purpose of this Application Guide
1.2
This application guide is intended for qualified personnel such as:
Automation engineers
l
Commissioning engineers who have experience operating with parameters and basic knowledge of AC drives
l
The application guide provides information on the initial configuration of the drive. The purpose of the guide is to provide information
on parameters for configuring and controlling the drive, an overview and procedures of the various user interfaces in iC7, typical
application examples, and troubleshooting of events in the drive.
Additional Resources
1.3
Additional resources are available with related information.
iC7-Automation Frequency Converters Design Guide provides information about the capability and functionality to design motor control
systems for Danfoss iC7 series.
iC7 Series Frequency Converters Installation Safety Guide provides important safety information related to iC7 drives.
iC7-Automation Frequency Converters Installation Guides cover the mechanical and electrical installation of drives.
Safety Symbols
1.4
The following symbols are used in Danfoss documentation.
Indicates a hazardous situation which, if not avoided, will result in death or serious injury.
Indicates a hazardous situation which, if not avoided, could result in death or serious injury.
Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
Indicates information considered important, but not hazard-related (for example, messages relating to property damage).
© 2023.11
Remarks
General Release 2
DANGER
WARNING
CAUTION
NOTICE
Software Version
3.0.4
AB318753549016en-000301 / 136R0284 |
11