Danfoss iC7 Motion Series Application Manual page 121

Application Guide | iC7 Series Motion
The following are the selections for the parameter.
Selection Number
0
1
Filters & Brake Chopper (Menu Index 3)
6.4
Filters & Brake Chopper Overview
6.4.1
This parameter group contains parameters for configuring, monitoring, and controlling the input filters, output filters, brake chopper,
and brake resistors.
Filters & Brake Chopper Status (Menu Index 3.1)
6.4.2
P 3.1.1 Brake Power
Description: Shows the power dissipated in the brake resistor.
Default Value: NA
Unit: kW
P 3.1.2 Average Brake Power
Description: Shows the average power dissipated in the brake resistor, calculated over 120 s.
Default Value: NA
Unit: kW
P 3.1.3 AHF Capacitor Connected
Description: Shows if the advanced harmonic filter (AHF) capacitor is connected.
Default Value: NA
Unit: -
Brake Chopper (Menu Index 3.2)
6.4.3
P 3.2.1 Brake Chopper
Description: Select the brake chopper operation mode.
Default Value: 0 [Disabled]
Unit: -
The following are the selections for the parameter.
© 2023.11
Selection Name
Disabled
Enabled
Parameter Type: Range (0.00 — \*)
Data Type: REAL
Parameter Type: Range (0.00 — \*)
Data Type: REAL
Parameter Type: Range (0 — 1)
Data Type: BOOL
Parameter Type: Selection
Data Type: UINT
Selection Description
Disables the function.
Enables the function.
Parameter Number: 2933
Access Type: Read Only
Parameter Number: 2934
Access Type: Read Only
Parameter Number: 5410
Access Type: Read Only
Parameter Number: 2935
Access Type: Read/Write
AB318753549016en-000301 / 136R0284 |
119