Danfoss iC7 Motion Series Application Manual page 376

Application Guide | iC7 Series Motion
Table 48: Summary Table (continued)
Group Numb Display Name
Numb er
er (Deci
(Hex) mal)
0x810 4258 Invalid Fieldbus Configu-
0 ration
0x810 4260 Redundant Controller
0 Missing
0x810 4261 Fieldbus Topology Mis-
0 match
0x810 4263 Ethernet Link Status
0 Changed
0x810 4265 Ethernet Redundancy Er-
0 ror
0x810 4266 X1 Cable Redundancy
0
0x810 4267 X2 Cable Redundancy
0
0x810 4268 FieldbusStartUp
0
0x810 4269 Network Time Protocol
0
0x810 4280 Controller Not in Run
0
0x810 4281 Interface Configuration
0 Change
0x810 5162 Alternative Control Place
0 due to Fieldbus Timeout
374
| © 2023.11
Description
An issue due to an invalid configuration of
the fieldbus connection has been detected.
Features not supported by the device, mis-
match between configured and actually avail-
able features or modules not available in the
device. See additional detail info.
One or more of the expected fieldbus con-
trollers are missing.
The current fieldbus topology does not
match the topology provided at commission-
ing time.
There has been detected a change of the Eth-
ernet link status. Additional info has details
about which port and state.
Primary or backup physical paths has been
detected missing.
Indicates that physical path from X1 interface
to the controller is missing or wrongly config-
ured.
Indicates that physical path from X2 interface
to the controller is missing or wrongly config-
ured.
Internal occurrence to mask away Topolo-
gyMismatch occurrence during startup
Information of Network Time Protocol server.
See detailed info.
Controller not in RUN state.
Interface configuration changed. See detailed
info.
Fieldbus process data timeout caused a
change to the alternative control place.
Type of Event Inverter and
Brake Chopper
Action
I F P Invert
W F er
X X
X
X
X
X
X
X
X
X
X
X
X
AB318753549016en-000301 / 136R0284
Brake