Danfoss iC7 Motion Series Application Manual page 375

Application Guide | iC7 Series Motion
Table 48: Summary Table (continued)
Group Numb Display Name
Numb er
er (Deci
(Hex) mal)
0x712 5602 Feedback Resolution/
0 Poles High
0x712 5603 Feedback Resolution/
0 Poles Low
0x712 5606 Feedback Unstable
0
0x712 4182 Motor Sync Loss
2
0x72F 4417 Feedback Option Fault
F
0x731 4418 Bad Speed Feedback
0
0x738 5500 Touch Probe not config-
0 ured
0x738 5501 Touch Probe invalid mode
0
0x738 6006 Touch Probe Timeout Er-
0 ror
0x750 4638 Drive to Drive Connection
0 Lost
0x758 5141 Control Panel Connection
0 Lost
0x758 5142 PC Connection Lost
0
0x810 4256 Address Conflict
0
0x810 4257 Ethernet Cable Fault
0
© 2023.11
Description
Feedback signal was slower than expected.
Feedback signal was faster than expected.
Feedback signal was inconsistent.
Select the drive response if the synchroniza-
tion between motor and drive is lost. This is
only relevant when using a permanent mag-
net or synchronous reluctance motor.
The Feedback Option is indicating a fault con-
dition.
Speed Feedback value is not reliable.
Touch Probe Positioning ist not started due to
missing configuration.
Operation mode is not valid to start Touch
Probe Positioning.
No touch probe event is detected during the
set time limit.
Drive to drive connection is lost.
The connection to the control panel is lost.
Control via control panel is released.
The connection to the PC tool is lost. PC con-
trol is released.
The fieldbus has identified an Address Con-
flict on the network which made the device
back off.
At link down a measurement is done to mea-
sure the distance to the far end of the cable,
indicating where the fault has occurred. This
warning occurs at distances > 4 m and Link
State Change Down. Actual distance shown
in detailed info.
Type of Event Inverter and
Brake Chopper
Action
I F P Invert
W F er
X C
X C
X C
X X C
X C
X C
X
X
X C
X X C
X
X
AB318753549016en-000301 / 136R0284 |
Brake
C
C
C
C
C
C
373