Danfoss iC7 Motion Series Application Manual page 306

Application Guide | iC7 Series Motion
P 8.2.2 Unit Selection
Description: Select the unit system used.
Default Value: \*
Unit: -
The following are the selections for the parameter.
Selection Number
0
1
P 8.2.3 Speed Unit
Description: Select the speed unit.
Default Value: 1 [RPM]
Unit: -
The following are the selections for the parameter.
Selection Number
0
1
Control Panel (Menu Index 8.3)
6.9.3
Readout Screen 1 (Menu Index 8.3.1)
6.9.3.1
P 8.3.1.1 Readout Field 1.1
Description: Select the parameter for readout field (screen 1 field 1).
Default Value: 0 [Automatic]
Unit: -
The following are the selections for the parameter.
Selection Number
0
9011
304
| © 2023.11
Parameter Type: Selection
Data Type: USINT
Selection Name
SI (metric units)
USCS (United States customary units)
Parameter Type: Selection
Data Type: USINT
Selection Name
Hz
RPM
Parameter Type: Selection
Data Type: UDINT
Selection Name
Automatic
Motor Speed
Parameter Number: 2801
Access Type: Read/Write
Selection Description
International system of units.
United States customary units.
Parameter Number: 2813
Access Type: Read/Write
Selection Description
Use Hz as speed unit.
Use RPM as speed unit.
Parameter Number: 300
Access Type: Read/Write
Selection Description
Automatically shows the actual value of
the selected control mode, for example
speed or torque.
Shows the actual motor speed.
AB318753549016en-000301 / 136R0284