Danfoss iC7 Motion Series Application Manual page 85

Application Guide | iC7 Series Motion
Application Software Structure and Overview
4
Understanding Application Software Structure Principles
4.1
The basic design principle of the application software structure and the related hierarchy refers to the setup of a typical iC7 drive.
The same application software structure is reused across all products within the iC7 series. This means that some of the parameter
groups or dedicated parameters may not be visible for all applications. Therefore, the indexes of parameters may not be sequential.
This design principle is followed to maintain consistency across all the different application software in the iC7 series. The application
software is designed in this manner to have the same look and feel across different iC7 series products, and enable easier and faster
troubleshooting.
6 Maintenance & Service
5 Application
3 Filters & Brake Chopper
Input
1 Grid
Filter
Conversion & DC-link
(rectifier, intermediate
8 Customization
Figure 65: Application Software Structure Overview
Parameter Groups, Related Content, and Settings
4.2
The detailed structure and hierarchy within the parameter groups can vary, depending on the purpose of the parameter group and
the total number of parameters. However, the design principle of the structure is to keep the overall sequence while commissioning or
setting up the drive within a logical structure. One example is that the Status parameter group is embedded into each main group (if
applicable) to provide quick and easy access to view real time status information of relevant data of parameters within this group.
All generic settings such as Grid, Power Conversion and DC-link, Filters & Brake Chopper, and Motor are accessed via parameter
l
group 1–4.
Most of the application-specific parameters are accessed via parameter group 5 Application.
l
Features and functions such as Maintenance & Service, Functional Safety, and Customization are in parameter group 6, 7, and 8.
l
The basic setup for external control signals and communication interfaces is done in parameter group 9 and 10.
l
Features and related parameters are grouped in individual parameter groups. Each feature has a parameter group of its own.
l
Status information for each parameter group is available separately for easy access.
l
The following table provides information about the parameter groups.
© 2023.11
Brake Chopper
Output
2 Power
Filter
circuit, inverter)
Basic I/Os:
Digital I/Os,
Analog I/Os
Relays
9 I/O
Option A
Option B
Option C
Option x
10 Connectivity
4 Motor
7 Functional
Safety
AB318753549016en-000301 / 136R0284 |
83