Danfoss iC7 Motion Series Application Manual page 129

Application Guide | iC7 Series Motion
P 4.1.24 AMA Progress
Description: Shows the progress of the Automatic Motor Adaptation (AMA).
Default Value: NA
Unit: %
P 4.1.26 Motor Temperature
Description: The analog temperature sensor has exceeded the configured value.
Default Value: NA
Unit: °C
P 4.1.28 Rs Measured
Description: When a Rs measurement has been stored for use after drive power recycle, the value is shown here; otherwise it is zero.
Default Value:
Unit: Ω
Motor Data (Menu Index 4.2)
6.5.3
General Settings (Menu Index 4.2.1)
6.5.3.1
P 4.2.1.1 Motor Type
Description: Select the motor type.
Default Value: 0 [Induction Motor]
Unit: -
The following are the selections for the parameter.
Selection Number
0
1
P 4.2.1.2 Number of Pole Pairs
Description: Set the number of pole pairs. For example, a 4-pole motor is set as 2 pole pairs.
Default Value: 2
Unit: -
P 4.2.1.3 AMA Mode
© 2023.11
Parameter Type: Range (0 — 100)
Data Type: REAL
Parameter Type: Range (-300 — 300)
Data Type: REAL
Parameter Type: Range (0 — 1000000)
Data Type: REAL
Parameter Type: Selection
Data Type: UINT
Selection Name
Induction Motor
Permanent Magnet Motor
Parameter Type: Range (0 — 65535)
Data Type: UINT
Parameter Number: 429
Access Type: Read Only
Parameter Number: 1630
Access Type: Read Only
Parameter Number: 433
Access Type: Read/Write
Parameter Number: 407
Access Type: Read/Conditional Write
Selection Description
Asynchronous Induction Motor.
Permanent Magnet Motor.
Parameter Number: 406
Access Type: Read/Conditional Write
AB318753549016en-000301 / 136R0284 |
127