Danfoss iC7 Motion Series Application Manual page 340

Application Guide | iC7 Series Motion
Description: Select the trigger mode for the digital input.
Default Value: 0 [None]
Unit: -
The following are the selections for the parameter.
Selection Number
0
1
2
3
P 9.4.6.7 T17 Pulse Min. Frequency
Description: Set the frequency representing 0% of the signal.
Default Value: 0
Unit: Hz
P 9.4.6.8 T17 Pulse Max. Frequency
Description: Set the frequency representing 100% of the signal.
Default Value: 110000
Unit: Hz
Input T18 (Menu Index 9.4.7)
6.10.2.3.8
P 9.4.7.1 T18 Terminal Mode
Description: Select the mode for the terminal.
Default Value: 3 [Digital input]
Unit: -
The following are the selections for the parameter.
338
| © 2023.11
Parameter Type: Selection
Data Type: UINT
Selection Name
None
Rising Edge
Falling Edge
Both Edges
Parameter Type: Range (0 — 110000)
Data Type: REAL
Parameter Type: Range (0 — 110000)
Data Type: REAL
Parameter Type: Selection
Data Type: UINT
Parameter Number: 2036
Access Type: Read/Write
Selection Description
No event trigger.
Trig event at rising edge.
Trig event at falling edge.
Trig event at both rising and falling edge.
Parameter Number: 2037
Access Type: Read/Write
Parameter Number: 2038
Access Type: Read/Write
Parameter Number: 2018
Access Type: Read/Write
AB318753549016en-000301 / 136R0284