Danfoss iC7 Motion Series Application Manual page 74

Application Guide | iC7 Series Motion
3. Use the START, STOP, and STOP COAST buttons (3) to perform drive operations. Use the sliders (4) to increase or decrease the
reference speed.
4. To reset the drive in case of a fault, click RESET FAULTS (5).
5.
For ease of access, click the Pin button (6) to make the control panel be constantly visible on the screen.
Datalogger
3.3.6
Introduction to Datalogger
3.3.6.1
The Datalogger in MyDrive Insight enables the monitoring of signals and related information for the selected signals.
Figure 50: Navigating to Datalogger
To access the Datalogger feature, select the drive (1), then go to Graphs and Reports (2) > Datalogger (3)
The following image shows the Datalogger main controls:
Figure 51: Datalogger Screen
1
Open the window to select available Datalogger files for
viewing.
3
Datalogger status.
72
| © 2023.11
1
2
3
4 5 6 7
2
2
The list of Datalogger settings.
4
Enable or disable Datalogger. When disabled, all
Datalogger configuration settings are inactive. When
enabled, Datalogger is active and operates based on the
configuration settings.
1
3
AB318753549016en-000301 / 136R0284