Danfoss iC7 Motion Series Application Manual page 86

Application Guide | iC7 Series Motion
Table 23: Parameter Group Description
Index
1
2
3
4
5
6
7
8
9
10
84
| © 2023.11
Parameter group name
Grid
Power Conversion & DC Link
Filters & Brake Chopper
Motor
Application
Maintenance & Service
Functional Safety
Customization
I/O
Connectivity
Description
Contains parameters for the configuring,
monitoring, and controlling the energy
source of the drive system. Typically, the
energy source is the grid. The menu also
lets the user configure grid protection set-
tings and view the condition of the grid.
Contains parameters to configure, moni-
tor, and control the power conversion of
the drive. The menu lets the user config-
ure protection settings of the power unit
and settings for the rectifier, DC link, and
inverter.
Contains parameters to configure, moni-
tor, and control the input filters, output fil-
ters, brake chopper, and brake resistors.
Contains parameters to configure motor,
motor control, and motor protection.
Contains parameters for application-spe-
cific features such as position control,
speed control, torque control, mechanical
brake control and many more.
Contains parameters exclusively related to
status, events, and service features such as
condition-based monitoring.
Contains non-safety-related parameters
for configuring Safe Torque Off, as well as
other safety features.
Contains parameters to customize and
adapt the behavior of the drive and user
interface design.
Contains hardware-related parameters to
configure digital or analog I/O's.
Parameters to configure the built-in and
optional communication of the drive sys-
tem.
AB318753549016en-000301 / 136R0284