Danfoss iC7 Motion Series Application Manual page 368

Application Guide | iC7 Series Motion
Table 48: Summary Table (continued)
Group Numb Display Name
Numb er
er (Deci
(Hex) mal)
0x610 4817 PLC Runtime Error
0
0x610 4832 Node Discovery
0
0x610 4833 Node Commissioning
0
0x610 4834 Node Missing
0
0x610 4853 StartupOccurrence
0
0x610 4854 ResetByDemand
0
0x610 4855 Internal Fault
0
0x610 4856 Internal Fault
0
0x610 4857 Software Update
0
0x610 6000 Motion Internal Fb Error
0
0x610 6001 Drive Disabled Error
0
0x610 6007 Motion License Missing
0
0x618 5260 Event Simulation
0
366
| © 2023.11
Description
The PLC runtime has stopped responding.
The application has been halted.
Node discovery and configuration are in
progress. The modulation is inhibited.
Nodes are being commissioned.
A previously commissioned node is no longer
available. The drive is waiting for the node to
be available. If the node has been removed,
recommission the drive.
This occurrence masks over various occur-
rences that might be active during startup,
that we dont want to show the end user
Drive reset is requested by user, and will be
performed shortly
An internal fault has been detected. Cycle
power, check the wiring if applicable, con-
tact the service provider if the fault persists.
Note the occurrence number for further trou-
bleshooting directions.
An internal fault has been detected (connec-
tion from controller). Cycle power, check the
internal wiring, contact the service provider
if the fault persists. Note the occurrence num-
ber for further troubleshooting directions.
The drive is currently performing an update
of the software.
Motion command is not executed due to In-
ternal Error.
Motion command is rejected when drive is
disabled. Please Start the Drive.
Motion License for the feature is not present.
The event with the number 5260 is simulated.
Type of Event Inverter and
Brake Chopper
Action
I F P Invert
W F er
X C
X RC
X C
X
X
X C
X RC
X C
X
X C
X
X C
X X C
AB318753549016en-000301 / 136R0284
Brake
C
C
C
C
C
C
C
C