Danfoss iC7 Motion Series Application Manual page 371

Application Guide | iC7 Series Motion
Table 48: Summary Table (continued)
Group Numb Display Name
Numb er
er (Deci
(Hex) mal)
0x61F 4605 Internal Communication
C Fault
0x61F 4606 Internal Communication
C Fault
0x61F 4639 High Speed Bus Sync Er-
C ror
0x61F 4648 High Speed Bus Error
C
0x61F 4858 Internal Fault
C
0x61F 4859 Internal Fault
C
0x61F 4860 Unexpected Time Adjust
C
© 2023.11
Description
An internal communication fault has been
detected. Cycle power, check the wiring if ap-
plicable, contact the service provider if the
fault persists. Note the occurrence number
for further troubleshooting directions.
An internal communication fault has been
detected. Cycle power, check the wiring if
applicable, contact the Danfoss supplier or
the service department if the fault persists.
Note the occurrence number for further trou-
bleshooting directions.
Internal error detected with high-speed bus
connection to parallel control unit.
Internal error detected with high-speed bus
connection to parallel control unit.
An internal fault has been detected. The
power system has not received the required
reference for modulation. Cycle power, check
the wiring if applicable, contact the Danfoss
supplier or the service department if the fault
persists. Note the occurrence number for fur-
ther troubleshooting directions.
An internal fault (connection from power
system) has been detected. Cycle power,
check the internal wiring, contact the service
provider if the fault persists. Note the occur-
rence number for further troubleshooting di-
rections.
An internal fault (unexpected time adjust-
ment) has been detected. Cycle power,
check the internal wiring, contact the service
provider if the fault persists. Note the occur-
rence number for further troubleshooting di-
rections.
Type of Event Inverter and
Brake Chopper
Action
I F P Invert
W F er
X C
X C
X C
X C
X X C
X X C
X C
AB318753549016en-000301 / 136R0284 |
Brake
C
C
C
C
C
369