Danfoss iC7 Motion Series Application Manual page 184

Application Guide | iC7 Series Motion
Selection Number
4
5
P 5.5.5.2.13 I/O Position Reference Logic
Description: Select how to form the position reference out of the 2 inputs when operating in I/O control.
Default Value: 0 [Source 1]
Unit: -
The following are the selections for the parameter.
Selection Number
0
1
2
3
4
5
6
7
8
P 5.5.5.2.14 I/O Position Reference Toggle Input
Description: Select an input for toggling between the 2 position reference sources selected when operating in I/O control and toggling
logic is used. A low signal selects the first source and high signal selects the second source.
Default Value:
Unit: -
Advanced control (Menu Index 5.5.6)
6.6.7.7
Commands (Menu Index 5.5.6.1)
6.6.7.7.1
P 5.5.6.1.1 Advanced Start Input
Description: Select inputs for starting in the forward direction when operating in advanced control.
182
| © 2023.11
Selection Name
Reference 2 input
Preset reference
Parameter Type: Selection
Data Type: UINT
Selection Name
Source 1
Source 2
Sum
Subtract
Divide
Multiply
Maximum
Minimum
Toggle
Parameter Type: Selection
Data Type: UINT
Selection Description
Use the reference from I/O reference 2.
Use reference from the preset reference.
Parameter Number: 1946
Access Type: Read/Write
Selection Description
Use value from source 1 only.
Use value from source 2 only.
Add references from source 1 and 2
together.
Subtract source 2 from source 1.
Divide source 1 with source 2.
Multiply source 1 with source 2.
Use highest value of source 1 and source
2.
Use lowest value of source 1 and source 2.
Toggle between source 1 and 2 using a
digital input.
Parameter Number: 1945
Access Type: Read/Write
AB318753549016en-000301 / 136R0284