Danfoss iC7 Motion Series Application Manual page 68

Application Guide | iC7 Series Motion
Getting Started with MyDrive Insight
3.3.2
As a prerequisite, ensure that MyDrive® Insight is installed on the device (PC or laptop). MyDrive® Insight can be downloaded and
installed from MyDrive® Suite, available here:
1.
To establish a point-to-point connection between the drive and the device, use the communication interface X0 and the RJ45
Ethernet port on the device by using a standard Ethernet cable.
If the device does not have an RJ45 Ethernet port or it is already in use, then a conventional adapter from USB-C to RJ45 can be
used. To connect several drives at the same time, use an Ethernet switch between the PC and the control unit.
Figure 40: Connection to the PC
1
Ethernet switch
2.
When the drive is powered up and in Ready state, open MyDrive® Insight on the device and the drive is recognized.
3.
To establish or confirm the connection, click the arrow button.
Figure 41: Confirm Connection

Once the connection is established, the drive is marked with a green connection symbol in MyDrive® Insight.
66
| © 2023.11
https://suite.mydrive.danfoss.com/
1
AB318753549016en-000301 / 136R0284