Danfoss iC7 Motion Series Application Manual page 65

Application Guide | iC7 Series Motion
1
Name and control state of the drive.
3
Previous and Next arrow icons. Press the icons to navigate
1 level above or below in the parameter group structure.
When the Previous or Next arrow is not shown, it indicates
that the view is at the top or bottom of the menu
structure, respectively.
Basic navigation techniques
To navigate through and within the different parameter groups, use the navigation buttons of the control panel.
To navigate to different parameter groups, press the up or down arrows of the control panel.
l
To navigate to parameter subgroups or parameters within a parameter group, press the left or right arrows of the control panel.
l
To navigate to a higher level in the parameter/parameter group screens press the Back button, and to navigate to a lower level press
l
the OK button.
iC7_Industry
0.0 rpm 0.0 Nm
1
Status
1.1.1 Grid Frequency
2
50.0 Hz
1.1.2 Line-To-Line Voltage (RMS)
408.1 V
1.1.3 L1-L2 Line Voltage (RMS)
407.3 V
Figure 35: Parameter Navigation
1
Previous button when in a parameter group.
Changing the Selections of a Parameter
3.2.9
When a parameter has selections, the parameter index and name are highlighted in black. The example parameter in this procedure is P
5.8.6.2.1 Ramp 1 Type.
iC7_Industry
0.0 rpm 0.0 Nm
Ramp 1
5.8.6.2.1 Ramp 1 Type Selector
Linear Ramp
5.8.6.2.2 Ramp 1 Accel. Time
5.00 s
5.8.6.2.3 Ramp 1 Decel. Time
5.00 s
Figure 36: A Parameter with Selections
1. To view the selections of the parameter, press the right arrow button or OK on the control panel. The selections available for the
parameter are shown on the screen.
© 2023.11
REM
0.0 kW
REM
0.0 kW
2
The menu readout header. It shows the first 3 signals
selected in Readout Screen 2. Editing this line also affects
Readout Screen 2.
4
Name of the application software that is active in the drive.
2
When parameters are defined as readout only, the current
value is shown below the parameter name. A black outline
around the parameter indicates that the value of the
parameter cannot be changed.
AB318753549016en-000301 / 136R0284 |
63