Danfoss iC7 Motion Series Application Manual page 75

Application Guide | iC7 Series Motion
5
Activate the force trigger. The 0–1 transition (rising edge)
triggers Datalogger manually. This function is typically
used with automatic triggers.
7
Apply any changed settings.
Configuring Datalogger
3.3.6.2
There are 2 main steps to configuring Datalogger:
Configure the signals to be recorded using Datalogger.
l
Configure the Datalogger settings.
l
1.
Open Datalogger
The Settings view opens.
2.
Enter the required and desired settings.
Figure 52: Datalogger settings
The following table describes the user interface elements:
© 2023.11
6
Arm Datalogger. The 0–1 transition (rising edge) readies
Datalogger for triggering.
AB318753549016en-000301 / 136R0284 |
73