Danfoss iC7 Motion Series Application Manual page 192

Application Guide | iC7 Series Motion
Selection Number
0
1
2
3
4
5
6
7
8
P 5.5.6.2.14 Adv Position Reference Toggle Input
Description: Select an input for toggling between the 2 position reference sources selected when operating in advanced control and
toggling logic is used. A low signal selects the first source and high signal selects the second source.
Default Value:
Unit: -
Start Settings (Menu Index 5.6)
6.6.8
Start Settings Overview
6.6.8.1
The application software provides the possibility to configure a DC start before entering normal motor control, for purposes of motor
pre-heating, pre-magnetization, DC holding, or a start delay.
DC Start Current %
DC Start Rise Time
DC Start Time
DC stator current control
0
Figure 77: Induction Motor Start from Zero Speed with DC Start and Start Zero Speed Time > 0
190
| © 2023.11
Selection Name
Source 1
Source 2
Sum
Subtract
Divide
Multiply
Maximum
Minimum
Toggle
Parameter Type: Selection
Data Type: UINT
Magnetization
Current Limit %
Nominal
Magnetization
Current
Start Z ero
Speed Time
Motor control
Selection Description
Use value from source 1 only.
Use value from source 2 only.
Add references from source 1 and 2
together.
Subtract source 2 from source 1.
Divide source 1 with source 2.
Multiply source 1 with source 2.
Use highest value of source 1 and source
2.
Use lowest value of source 1 and source 2.
Toggle between source 1 and 2 using a
digital input.
Parameter Number: 1977
Access Type: Read/Write
Magnetization
Current
Speed
Time
Run Request
AB318753549016en-000301 / 136R0284