Danfoss iC7 Motion Series Application Manual page 224

Application Guide | iC7 Series Motion
Default Value: 0
Unit: Hz
P 5.8.8.6 Band 3, High Limit
Description: Set the bypass hysteresis speed band, high limit.
Default Value: 0
Unit: Hz
P 5.8.8.7 Band 4, Low Limit
Description: Set the bypass hysteresis speed band, low limit.
Default Value: 0
Unit: Hz
P 5.8.8.8 Band 4, High Limit
Description: Set the bypass hysteresis speed band, high limit.
Default Value: 0
Unit: Hz
Load Drooping (Menu Index 5.8.9)
6.6.10.13
P 5.8.9.1 Load Drooping Mode
Description: Select the load drooping mode - Only available in FVC+ mode.
Default Value: 0 [Static]
Unit: -
The following are the selections for the parameter.
Selection Number
0
1
2
222
| © 2023.11
Parameter Type: Range (0 — 100)
Data Type: REAL
Parameter Type: Range (0 — 100)
Data Type: REAL
Parameter Type: Range (0 — 100)
Data Type: REAL
Parameter Type: Range (0 — 100)
Data Type: REAL
Parameter Type: Selection
Data Type: UINT
Selection Name
Static
Dynamic
Combined
Parameter Number: 4524
Access Type: Read/Write
Parameter Number: 4525
Access Type: Read/Write
Parameter Number: 4526
Access Type: Read/Write
Parameter Number: 4527
Access Type: Read/Write
Parameter Number: 670
Access Type: Read/Write
Selection Description
Simple and robust drooping, but will
result in a speed error ondepending load.
This will run at correct speed independent
of load, but requires syncroniced start
stop to avoid torque deviation between
drives.
This will run a mix of static and dynamic
drooping at low speed, otherwise
identical with dynamic.
AB318753549016en-000301 / 136R0284