Danfoss iC7 Motion Series Application Manual page 187

Application Guide | iC7 Series Motion
P 5.5.6.1.8 Advanced Coast Inverse Logic
Description: Select the combination logic for the inverted coast command of advanced control.
Default Value: 0 [Source 1]
Unit: -
The following are the selections for the parameter.
Selection Number
0
1
2
3
4
5
6
7
P 5.5.6.1.9 Advanced Reversing Input
Description: Select inputs for inverting the reference signal when operating in advanced control. The reverse command does not
provide a start signal.
Default Value:
Unit: -
P 5.5.6.1.10 Advanced Reverse Logic
Description: Select the combination logic for the reverse command of advanced control.
Default Value: 2 [AND]
Unit: -
The following are the selections for the parameter.
Selection Number
0
1
2
3
© 2023.11
Parameter Type: Selection
Data Type: UINT
Selection Name
Source 1
Source 2
AND
OR
NAND
NOR
XOR
XNOR
Parameter Type: Selection
Data Type: UINT
Parameter Type: Selection
Data Type: UINT
Selection Name
Source 1
Source 2
AND
OR
Parameter Number: 1936
Access Type: Read/Write
Selection Description
Use value from source 1 only.
Use value from source 2 only.
Logically AND source 1 and 2.
Logically OR source 1 and 2.
Logically NAND source 1 and 2.
Logically NOR source 1 and 2.
Logically XOR source 1 and 2.
Logically XNOR source 1 and 2.
Parameter Number: 4730
Access Type: Read/Write
Parameter Number: 1937
Access Type: Read/Write
Selection Description
Use value from source 1 only.
Use value from source 2 only.
Logically AND source 1 and 2.
Logically OR source 1 and 2.
AB318753549016en-000301 / 136R0284 |
185