Danfoss iC7 Motion Series Application Manual page 172

Application Guide | iC7 Series Motion
Default Value:
Unit: -
P 5.5.1.3 Fieldbus Control Active Output
Description: Select an output terminal indicating that the drive is in fieldbus control.
Default Value:
Unit: -
P 5.5.1.4 I/O Control Active Output
Description: Select an output terminal indicating that the drive is in I/O control.
Default Value:
Unit: -
P 5.5.1.5 Advanced Control Active Output
Description: Select an output terminal indicating that the drive is in advanced control.
Default Value:
Unit: -
Control Place Settings (Menu Index 5.5.2)
6.6.7.3
P 5.5.2.1 Control Place Selection
Description: Select the active control place.
Default Value: 4 [Advanced control]
Unit: -
The following are the selections for the parameter.
Selection Number
1
2
3
4
P 5.5.2.7 Control Place Independent Reset
170
| © 2023.11
Parameter Type: Selection
Data Type: UINT
Parameter Type: Selection
Data Type: UINT
Parameter Type: Selection
Data Type: UINT
Parameter Type: Selection
Data Type: UINT
Parameter Type: Selection
Data Type: UINT
Selection Name
Local control
Fieldbus control
I/O control
Advanced control
Parameter Number: 5178
Access Type: Read/Write
Parameter Number: 5197
Access Type: Read/Write
Parameter Number: 5177
Access Type: Read/Write
Parameter Number: 4727
Access Type: Read/Write
Parameter Number: 114
Access Type: Read/Write
Selection Description
The drive is controlled by a connected
control panel.
The drive is controlled via a fieldbus.
The drive is controlled via I/O.
The drive is controlled via a combination
of I/O and fieldbus.
AB318753549016en-000301 / 136R0284