Danfoss iC7 Motion Series Application Manual page 64

Application Guide | iC7 Series Motion
3. Add a readout to the screen by navigating to the Add readout button on the UI and pressing it. You can move between the Add
readout and Remove readoutbuttons by pressing the left and right arrow buttons on the control panel.
4.
After pressing the Add readout button, select the readout to be added.
Readout Screen 1
Motor Frequency
Line-To-Line Voltage (RMS)
Figure 32: Readout Screen Update
5.
Add more readouts by pressing the Add readout button and selecting a readout.
6.
After selecting the readouts to be added or removed from the list, press OK.
7. To exit the screen content editing mode, press the Home or Back button.
iC7_Industry
Motor Frequency
Line-To-Line Voltage
Figure 33: Updated Readout Screen
The readout screens can also be adjusted using parameter group 8.3 Control Panel. For more information, see Customization
(Menu Index 8).
Parameter Group Screen and Overall Navigation
3.2.8
Pressing the Home/Menu button toggles between the readout screens and the parameter group screen. The content of the parameter
group screen can vary depending on the current level of the parameter group. A typical parameter group screen is shown in the
following image.
iC7_Industry
0.0 rpm 0.0 Nm
Industry Application
1 Grid
2 Power conversion & DC-link
3 Filters & Brake Chopper
4 Motor
Figure 34: Parameter Group Screen
62
| © 2023.11
+
REM
0.0 Hz
0.0 Hz
(...399.5 v)
1
REM
2
0.0 kW
3
4
NOTICE
AB318753549016en-000301 / 136R0284