Danfoss iC7 Motion Series Application Manual page 114

Application Guide | iC7 Series Motion
Default Value: 1 [Fault]
Unit: -
The following are the selections for the parameter.
Selection Number
1
2
P 2.3.1.6 Inverter Thermal Overload Response
Description: Select the mode of inverter thermal overload protection.
Default Value: 1 [Fault]
Unit: -
The following are the selections for the parameter.
Selection Number
1
2
P 2.3.1.7 Ground Fault 0 Response
Description: Select a response if a high-impedance ground fault occurs.
Default Value: 9 [Fault, ramp to coast]
Unit: -
The following are the selections for the parameter.
Selection Number
0
9
P 2.3.1.8 Constant Loss Controller
Description: Enables the constant-loss controller. The function maintains a constant temperature in the drive at low-load conditions.
112
| © 2023.11
Parameter Type: Selection
Data Type: UINT
Selection Name
Fault
Automatically derate
Parameter Type: Selection
Data Type: UINT
Selection Name
Fault
Automatically derate
Parameter Type: Selection
Data Type: UINT
Selection Name
No response
Fault, ramp to coast
Parameter Number: 2340
Access Type: Read/Write
Selection Description
The drive issues a fault and stops.
The drive continues operation with
derated performance.
Parameter Number: 2341
Access Type: Read/Write
Selection Description
The drive issues a fault and stops.
The drive continues operation with
derated performance.
Parameter Number: 2347
Access Type: Read/Write
Selection Description
The event is ignored.
Issues a fault, ramps down, and coast.
AB318753549016en-000301 / 136R0284