Danfoss iC7 Motion Series Application Manual page 181

Application Guide | iC7 Series Motion
Description: Select the mode of the start signal.
Default Value: 0 [State High Start]
Unit: -
The following are the selections for the parameter.
Selection Number
0
1
2
References (Menu Index 5.5.5.2)
6.6.7.6.2
P 5.5.5.2.1 I/O Speed Reference
Description: Select the speed reference sources for when the drive operates in I/O control. Select 2 sources to combine them into 1
reference value.
Default Value: [3,0]
Unit: -
The following are the selections for the parameter.
Selection Number
0
2
3
4
5
P 5.5.5.2.2 I/O Speed Reference Logic
Description: Select how to form the speed reference out of the 2 sources when operating in I/O control.
Default Value: 0 [Source 1]
Unit: -
© 2023.11
Parameter Type: Selection
Data Type: UINT
Selection Name
State High Start
Rising Edge Start
High Pulse Start
Parameter Type: Selection
Data Type: UINT
Selection Name
None
Fieldbus reference
Reference 1 input
Reference 2 input
Preset reference
Parameter Type: Selection
Data Type: UINT
Parameter Number: 211
Access Type: Read/Write
Selection Description
Start command remains as long as input is
true.
Start command is set when input
becomes true and remains latched until
stop command is given. Start remains
latched over stop if input is kept true.
Start command is set when input
becomes true and remains latched until
stop command is given.
Parameter Number: 1913
Access Type: Read/Write
Selection Description
No source selected equals a 0 value.
Use reference from the fieldbus.
Use the reference from I/O reference 1.
Use the reference from I/O reference 2.
Use reference from the preset reference.
Parameter Number: 1910
Access Type: Read/Write
AB318753549016en-000301 / 136R0284 |
179