Danfoss iC7 Motion Series Application Manual page 148

Application Guide | iC7 Series Motion
The following are the selections for the parameter.
Selection Number
0
2
1
P 4.5.3 Disconnected Motor Response
Description: Select the response to a disconnected motor.
Default Value: 0 [No response]
Unit: -
The following are the selections for the parameter.
Selection Number
0
3
P 4.5.4 ETR Overtemperature Response
Description: Select the response to motor overtemperature indicated by the electronic thermal relay (ETR).
Default Value: 0 [No response]
Unit: -
The following are the selections for the parameter.
Selection Number
0
1
3
9
10
P 4.5.5 Motor Thermistor Input
Description: Select an input for the motor thermistor feedback.
146
| © 2023.11
Selection Name
No response
Warning
Fault
Parameter Type: Selection
Data Type: UINT
Selection Name
No response
Motor Check
Parameter Type: Selection
Data Type: UINT
Selection Name
No response
Info
Warning
Fault, ramp to coast
Fault
Selection Description
The event is ignored.
The drive issues a warning.
The drive issues a fault and coasts the
motor.
Parameter Number: 2349
Access Type: Read/Write
Selection Description
The event is ignored.
The drive checks if the motor is
reconnected and resumes operation.
Parameter Number: 2825
Access Type: Read/Write
Selection Description
The event is ignored.
The event is logged in the event log.
The drive issues a warning.
Issues a fault, ramps down, and coast.
The drive issues a fault and coasts the
motor.
AB318753549016en-000301 / 136R0284