Danfoss iC7 Motion Series Application Manual page 238

Application Guide | iC7 Series Motion
P 5.11.2 Enable Inching Input
Description: Select a terminal to enable inching.
Default Value:
Unit: -
P 5.11.3 Inching Ramp Time
Description: Set the ramp time for inching.
Default Value: 10
Unit: s
P 5.11.4 Inching Reference 1
Description: Set reference 1 for inching.
Default Value: 15
Unit: Hz
P 5.11.5 Inching Activate Input 1
Description: Select the terminal to inching with reference 1. Enable inching input must be active.
Default Value:
Unit: -
P 5.11.6 Inching Reference 2
Description: Set reference 2 for inching.
Default Value: -15
Unit: Hz
P 5.11.7 Inching Activate Input 2
Description: Select the terminal to inching with reference 2. Enable inching input must be active.
Default Value:
Unit: -
P 5.11.8 Inching Active Output
Description: Select the output terminal or status bit indicating that inching is active.
236
| © 2023.11
Parameter Type: Selection
Data Type: UINT
Parameter Type: Range (0.01 — 3600)
Data Type: REAL
Parameter Type: Range (-1000 — 1000)
Data Type: REAL
Parameter Type: Selection
Data Type: UINT
Parameter Type: Range (-1000 — 1000)
Data Type: REAL
Parameter Type: Selection
Data Type: UINT
Parameter Number: 1080
Access Type: Read/Write
Parameter Number: 1083
Access Type: Read/Write
Parameter Number: 1082
Access Type: Read/Write
Parameter Number: 1084
Access Type: Read/Write
Parameter Number: 1085
Access Type: Read/Write
Parameter Number: 1086
Access Type: Read/Write
AB318753549016en-000301 / 136R0284