Overview When Parameterizing - Siemens SIMODRIVE 611 universal Function Manual

3 Parameterizing the Board
3.1

Overview when parameterizing

3.1 Overview when parameterizing
General
information
SIMODRIVE 611 universal
FEPROM
(non–volatile
memory)
Drive B
Drive A
Para–
meter
Para–
set
meter
set
Serial
interface
X471)
Serial CP 5511 (PCMCIA card with adapter)
interface
or
(e.g. COM1)
CP 5611 CP 5613 (short PCI card)
PG/PC
Fig. 3-1 Overview when parameterizing
3-88
You can parameterize "SIMODRIVE 611 universal" as follows:
S
Using the display and operator unit on the front panel of
"SIMODRIVE 611 universal"
S
Using the parameterizing and start–up tool
(SimoCom U) on a PG/PC
– SimoCom U via serial interface (RS232/RS485)
––> refer to Chapter 3.3.3
– SimoCom U via PROFIBUS–DP (CP 5511/CP 5611/CP 5613)
––> refer to Chapter 3.3.4
RAM
(volatile
memory)
Drive B
Save
Drive A
Para–
meter
Para–
set
Switching on
meter
set
POWER–ON
RESET
PROFIBUS DP
interface
(e.g. X423)
or (from SW 3.1)
Parameterizing
and start–up tool
"SimoCom U"
Setup.exe
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
Display and
operator unit
+ P
to
display
and
change
parameters
Online operation
––> the parameter set of a drive is
processed in the RAM of
"SIMODRIVE 611 universal"
Offline mode
––> the parameter set is processed in
a file on the PG/PC
E Siemens AG 2005 All Rights Reserved
08.01 01.99 10.99
–