Siemens SIMODRIVE 611 universal Function Manual page 582

6 Description of the Functions
6.11 Motor changeover for induction motors (from SW 2.4)
Table 6-61 Motor data set–dependent parameters, continued
Motor data set
1 2
1127 2127 3127
1129 2129 3129
1130 2130 3130
1132 2132 3132
1134 2134 3134
1135 2135 3135
1136 2136 3136
1137 2137 3137
1138 2138 3138
1139 2139 3139
1140 2140 3140
1141 2141 3141
1142 2142 3142
1145 2145 3145
1146 2146 3146
1147 2147 3147
1) 1)
1148 2148 3148
1150 2150 3150
1151 2151 3151
1160 2160 3160
1180 2180 3180
1181 2181 3181
1182 2182 3182
1230:8 2230:8 3230:8
1233:8 2233:8 3233:8
1235:8 2235:8 3235:8
1238 2238 3238
1240:8 2240:8 3240:8
1241:8 2241:8 3241:8
1242:8 2242:8 3242:8
1243:8 2243:8 3243:8
1245 2245 3245
1246 2246 3246
1256:8 2256:8 3256:8
1257:8 2257:8 3257:8
6-582
3 4
4127 Voltage at f = 0, V/Hz operation
4129 cos phi power factor
4130 Rated motor power
4132 Rated motor voltage
4134 Rated motor frequency
4135 Motor no–load voltage
4136 Motor no–load current
4137 Stator resistance, cold
4138 Rotor resistance, cold
4139 Stator leakage reactance
4140 Rotor leakage reactance
4141 Magnetizing reactance
4142 Speed at the start of field weakening
4145 Stall (standstill) torque reduction factor
4146 Maximum motor speed
4147 Speed limiting
1) 1)
4148 Speed at the start of the stall power
4150 P gain, flux controller
4151 Integral action time, flux controller
4160 Speed at the start of flux sensing
4180 Lower current limit adaptation
4181 Upper current limit adaptation
4182 Factor, current controller adaptation
4230:8 1st torque limit value
4233:8 Regenerative limiting
4235:8 1st power limit value
4238 Current limit value
4240:8 Offset, torque setpoint (speed controlled)
4241:8 Normalization, torque setpoint
4242:8 Offset, torque setpoint (torque controlled)
4243:8 Normalization, torque/power reduction
4245 Threshold for speed–dep. Msoll smoothing
4246 Hysteresis for speed–dep. Msoll smoothing
4256:8 Ramp–function generator, ramp–up time
4257:8 Ramp–function generator, ramp–down time
SIMODRIVE 611 universal Description of Functions (FBU) – 04.05 Edition
! not 611ue !
Meaning
E Siemens AG 2005 All Rights Reserved
04.99 01.99